InFocus LP650 Replacement Instructions
Lamp
Hide thumbs
Also See for LP650:
- User manual (47 pages) ,
- Руководство пользователя (41 pages) ,
- Brochure (4 pages)
Advertisement
Quick Links
LP650 Lamp Replacement Instructions
Use the chart below to interpret the LED messages.
1
2
3
4
5
6
7
8
Turn off the projector.
Unplug the power cord.
Allow the projector to cool for 60 minutes.
Remove the two screws that fasten the lamp door
to the bottom of the projector.
Lift the lamp door up and remove it.
Loosen the screw that fastens the lamp module to
the projector.
Remove the lamp module. Please dispose of the
module in an environmentally proper manner.
Install the new module in the projector. Make
sure it is fully seated.
Advertisement
Related Manuals for InFocus LP650
Summary of Contents for InFocus LP650
- Page 1 LP650 Lamp Replacement Instructions Use the chart below to interpret the LED messages. Turn off the projector. Unplug the power cord. Allow the projector to cool for 60 minutes. Remove the two screws that fasten the lamp door to the bottom of the projector.
- Page 2 Replace the lamp door and tighten the two screws. Plug the power cord in and press the Power button. Allow the projector to run for one minute. To reset the lamp timer, press and hold down the Volume + and Volume - buttons for ten seconds.