InFocus IN35 Setup Instructions
Infocus in35: supplementary guide
Hide thumbs
Also See for IN35:
- Technical specifications (4 pages) ,
- User manual (39 pages) ,
- Quick start manual (9 pages)
Advertisement
Quick Links
Download this manual
See also:
User Manual
RS-232 Setup Instructions
Communication Configuration
Baud Rate
19,200bps
Data Bits
8
Parity
None
Stop Bits
1
Flow Control
None
Emulation
VT100
Required Cables
Null modem cable - female to female DB9 connector (9-pin serial)
RJ45 to DB9 adapter - InFocus part# SP-RJ45-ADPT
See the end of document for wiring diagram and instructions.
Advertisement
Related Manuals for InFocus IN35
Summary of Contents for InFocus IN35
- Page 1 Parity None Stop Bits Flow Control None Emulation VT100 Required Cables Null modem cable - female to female DB9 connector (9-pin serial) RJ45 to DB9 adapter - InFocus part# SP-RJ45-ADPT See the end of document for wiring diagram and instructions.
- Page 2 The request can be a read request (indicated by a “?”) or a write request (indicated by 1 to 4 ASCII digits). A read request will report information to you, such as lamp hours. A write request is to tell the projector to change a setting.
- Page 3 Power Up (PWR99999) Most programs do not require a line feed after a command. Using a line feed, may cause the projector to respond with a “?” indicating an invalid command. Commands should respond within seconds of entering a command. If it does not, then there may issues with your connection, syntax or RS-232 software.
- Page 4 Source Dependent Settings Cross reference of Input and associated Source ID Connector Source ID VESA VESA Composite S-Video Table values are in the format “[Range], Initial value” Function Prefix Auto Color Space Enable Auto Image Aspect Ratio Auto Video Standard Enable Blue Gain BrilliantColor Look...
- Page 5 Audio Mute Tracking Overscan Preset Red Gain Red Offset Sharpness Sync Threshold Adjust Color Temp Tint Save User1 Preset Save User2 Preset Save User3 Preset Audio Volume Vertical Position Video Standard White Peaking Source Independent Settings Function Chime Enable Auto Power Enable Auto Source Enable Blank Screen Enable Serial 1 Baud Rate...
- Page 6 Computer Advance Color Coordinate Adjust Enable Source Enable 0 Source Enable 1 Source Enable 2 Source Enable 3 Ceiling Current Subsource Configuration Version Horizontal Keystone Vertical Keystone Display Messages Enable Power-up Source Startup Logo Echo Received Char 1 Echo Received Char 2 Custom Key Program System Error Condition Flash Mode Reset...
- Page 7 Factory Reset Source Advance System Power Enable Source 1 Program Source 2 Program Source 3 Program Source 4 Program Source Screen Save Time Sequence Version System State Test Pattern Enable Test Pattern Select User Preset 1 Saved Status User Preset 2 Saved Status User Preset 3 Saved Status Unit Part Number Unit Serial Number...
- Page 8 RJ45 Adapter Cable Pin-outs Most RJ-45 to DB9 adapters ship fully assembled, however, some are available only partially assembled, allowing them to be customized if necessary. Additionally, some organizations may wish to build their own adapters. The pin-outs below are provided to enable the completion of these adapters. DB-9 (Female) to RJ-45 (Male) RS-232 Serial Null Modem Adapter Wiring RJ-45 (Male Connector) Pin Numbering RJ-45 pins are numbered as shown on this male RJ-45 connector...