Assembly Instructions - KBO Breeze Owner's Manual

Assembly Instructions

NOTICE: The following assembly steps are only a general guide to assist in the assembly of your KBO Bike and is not a complete or
mechanic to assist in the assembly, repair and maintenance of your bicycle. For detailed instructions please view the KBO Breeze
assembly video found at www.kbobike.com.
Step 1 : Install the handle bars. Remove the four screws from the stem, ensuring the linear markings on the handlebars are centered and
handlebars are adjusted to a comfortable position. Finally, tighten the screws with the assembly tool.
Step 2 : Install the front wheel. Remove the plastic axle guards from the front wheel being sure not to touch the brake rotor set. Open the quick
skewer and remove the thumb nut and cone spring. Carefully lower the fork and ensure the brake rotor goes into the caliper. Next align
the dropouts with the axle of the wheel hub to make sure the fork dropouts are fully seated on the axle. Install the quick skewer starting
from the brake rotor side of the wheel and then push the quick release skewer through the hub. Keep two cone springs pointed towards
the wheel hub. Tighten the thumb nut until the quick release lever is held in line with the axle, and then use your palm of your hand to
close the quick release skewer.
Step 3 : Install fenders&headlight. Attach the front fender and the headlight by the screw.
Step 4
6