Table of Contents
Advertisement
The guide consists of a series of steps presented in a
checklist. Begin the checks with the power off, and the
power cord disconnected.
Checklist:
1.
Check exterior covers for damage (loose, broken, or
sharp edges).
2.
Power-off the computer. Disconnect the power
cord.
3.
Check the power cord for:
a.
b.
c.
4.
Remove the cover.
5.
Check for any obvious non-IBM alterations. Use
good judgment as to the safety of any non-IBM
alterations.
6.
Check inside the unit for any obvious unsafe
conditions, such as metal filings, contamination, water
or other liquids, or signs of fire or smoke damage.
7.
Check for worn, frayed, or pinched cables.
8.
Check that the power-supply cover fasteners (screws
or rivets) have not been removed or tampered with.
© Copyright IBM Corp. 1998
A third-wire ground connector in good
condition. Use a meter to measure third-wire
ground continuity for 0.1 ohm or less between
the external ground pin and frame ground.
The power cord should be the appropriate type
as specified in the parts listings.
Insulation must not be frayed or worn.
xv
Advertisement
Table of Contents
