AVE TH5 Operating Manual page 37

(e.g. display request 'connect with bicycle') by the bike battery or via USB-port by a computer
or USB-charger (display indication 'USB connected').
Intuvia stores the last displayed drive data, including battery level, support level, trip distance
and time, remaining range, and can help to evaluate and plan trips at home or during a break.
→ Charging status of the battery
Beside the LED indicators on the battery, you can control the battery status during a ride on the
display (f) of the operating computer (3).
Each bar in the battery icon (f) corresponds with a capacity of about 20%:
100 % to 80 % of the capacity
20 % to 5 % of the capacity, the battery should be recharged.
Less than 5% of capacity, the e-drive support ends. The LEDs of the battery level
indicator expire.
If the lighting is supplied by battery power (country specific), then the first appearance of the
battery icon 'empty' indicates, that there is still enough power for about 2 hours of light. If the
icon starts blinking, the lighting will be available only for a short time.
In the case of German bike versions compliant with the Highway Code, the light power is
supplied by a hub dynamo. In this case, the battery icon on the display does not matter for the
lighting.
If the operating computer is removed from the holder, the previously displayed battery power
status is stored and can be accessed anywhere.
→ Set the e-drive support mode
The operating computer allows you to set the support level of the e-drive unit, anytime during
a ride.
Following support levels are available:
„OFF" the e-power is switched off, the Pedelec can be driven like a normal bicycle by
pedaling
„ECO" economic e-power support, optimized for long cruising range
„TOUR" normal e-power support, daily cruising, tours
„SPORT" more e-power support, more acceleration (hills) and drive off torque (sporty)
„TURBO" maximal e-power support, assistance at high cadence and speed
For increasing the e-power mode, press the ' + ' button (13) repeatedly, until the desired mode
appears on the display (b), for decreasing use the ' – ' button (12).
The supplied motor power is displayed at Intuvia (a). The maximum power indication depends
on the choosen support level.
37
Original Operating Manual 1-2013