Table of Contents
Advertisement
RKP1015 / RKP1017
Technical Notes
Operating System Compatibility
Introduction
Rev. : 1.0
2. Read Before Installation
For Windows 98/98 SE systems
HID (Human Interface Device) driver must be installed prior to using
●
the USB KVM switch. To install the HID driver, first connect a USB
keyboard and mice directly to computer (before installing KVM switch)
then follow the Windows installation instructions, this will install the HID
device driver and allow the use of the KVM switch.
Note :
Failure to do so may result in Windows not being able to detect
keyboard and mouse.
If a mouse recognition error is displayed during system boot:
●
"Windows did not detect a mouse attached to the computer.You can
safely attach a serial mouse now. To attach a mouse to a PS/2 mouse
port, you must first turn the computer off"
a) Press the Tab key once to select the check box.
b) Press the Space bar once which will place a check in the box
"Do not show this message again"
c) Press the Enter key once and Windows will continue to boot and
will then recognize the mouse.
Any USB-enabled operating system such as Windows® 98,
●
Windows® 98SE, Windows® 2000, Windows® XP or higher.
Windows® 95 are not recommended because of immature USB
●
support.
P.2
User Manual
Advertisement
Table of Contents
