3. 3 A
SSEMBLING THE MOTOR ON THE GEARBOX
For gearboxes type CE12 and CE14-CE15, the procedure is different from all other gearboxes.
3.3.1 Motor shaft with key
•
ASSEMBLING THE MOTOR FLANGE ON THE MOTOR
Step 1
Some motors have fixing holes that are in the same position as those for fixing the motor flange to the
gearbox. In this case, the flange is only a centering element, therefore it must be assembled on the
motor as shown in picture a).
For all other motors, the flange must be assembled as shown in picture b) or picture c).
a)
03
For horizontal mounting, the drain hole (3c) on the motor flange (03) must be at the bottom.
•
ASSEMBLING THE PINION ON THE MOTOR SHAFT
Step 2
Fit the pinion (09) on the motor shaft, together with plug+O-ring (18) and spacer (17 - only if necessary).
18
Motor shaft
Only for very small motor shafts, there can be an adaptation bush (19), that must be fixed on the motor
shaft by means of a screw (19a), to be locked with the relevant sealing ring (19b).
USE AND MAINTENANCE MANUAL
2-Speed Gearboxes Series CE
b)
hex screw
3c
Motor shaft
- G
CE 12 - 14 - 15
EARBOX TYPE
03
3c
18
17
Motor shaft
.CE.GEN.ENG.DOCX
M
Issued
2018
Page 24 / 59
c)
hex nut
stud bolt
19b
19
Rev.03
03
3c
19a