Summary of Contents for Nayer 103-8002
- Page 1 ASSEMBLY MANUAL PARTY TENT 10' x 20' x 9'2" (3 x 6 x 2.8 m) Model NO.: 103-8002 Tools required for assembly (not included)
- Page 2 PARTS LIST Qty. Part# Description Drawing Incline Bar Horizontal Tube Post Tube 3-Way Connector 4-Way Connector Foot pads Roof Cover Front Door Panel Back Door Panel Side Panel Ball Tie Down Nylon Rope ASSEMBLY PREPARATION ASSEMBLY PREPARATION Place all parts from the packaging box in a cleared area and arrange them on the ground in front of you. Remove all packaging materials and place them back in the box.
- Page 3 ASSEMBLY Tools required for assembly (not included) Step 1 ● Lay out the roof frame parts as shown below. ● Please note: The Parts #2 are used to form the side and peak. The Parts #1 are used to form the roof rafter. ●...
- Page 4 ASSEMBLY Step 2 ● Connect 4 legs of one side to the 4-way and 3-way connectors. Step 3 ● Unfold the cover with the grommets toward the cover's bottom and place the cover over the frame. The flared edges should be located at each of the 4 corners of the frame.
- Page 5 ASSEMBLY Step 4 ● Connect the 4 legs for the other side the same way. And then attach the cover to the frame with ball tie downs. ● To properly install a bungee and starting at the four corners of the cover: Insert the ball tie downs into the eyelets and wrap the cord around the tube and hook it over the ball.
- Page 6 ASSEMBLY Step 6 ● Door Panel and Side Panel Assembly. ● There are two door panels(one front panel and one back panel) and two side panels in total.
- Page 7 ASSEMBLY Step 6 Measure out at least 36in from each leg. Screw each anchor into the ground leaving 2in between the ground and the eye of each anchor. ● We strongly recommend that your unit be anchored 36in from each leg although this may not be possible in all cases. DO install anchors as close to 36in away from legs as possible.