Table of Contents
Advertisement
In your washer you will find:
• 1 hose guide.
• 2 inlet hoses.
• User guide
Drain Hose
1. Carefully pull the drain hose out from the back
of the washer by pulling the exposed part of the
hose downward and outward.
2. To guide the drain hose over the tub or
standpipe the hose guide MUST be fitted to the
drain hose.
To prevent siphoning the drain
hose should not extend more
than 20mm from the end of the
guide. The height of the
standpipe or tub should be
between 850 – 1200mm. The
drain hose can be trimmed to
length.
3. Place the drain hose in the tub or standpipe. Do
not fit the hose to a drain spigot. Drainage must
not be airtight in order to prevent siphoning.
Electrical Connection
• This appliance must be supplied with a 220 – 240V, 50Hz, sinusoidal, 10A electrical supply.
• Check the power cord for damage, making sure it is not squashed or twisted.
• A damaged power cord must be replaced by a Fisher & Paykel trained and supported service technician, in
order to avoid a hazard.
• The appliance must not be operated until it is repaired, as there is a risk of electric shock.
https://producthelp.fisherpaykel.com/nz/Wash/Top_Loaders/WashSmart/WA70T60GW1/User_Guide_WA70T60GW1/03_Inst...
Fitting the drain hose guide
Updated: Wed, 20 Jan 2021 23:10:07 GMT
Powered by
4
Advertisement
Table of Contents
