Configuring The Cisco Sfs 3504 Server Switch - Cisco SFS 3504 Installation And Configuration Note

Configuring the Cisco SFS 3504 Server Switch

Enter the show card command to verify that the switch is operational and that the system acknowledges
Step 6
the new module and has brought it online. If the output of the show card command shows the oper code
as "normal" and boot status as "success," as shown in the example below, proceed to the next step in
configuring the switch.
SFS-3504> show card
================================================================================
================================================================================
slot type
--------------------------------------------------------------------------------
2
5*
================================================================================
================================================================================
slot stage
--------------------------------------------------------------------------------
2
5
================================================================================
================================================================================
slot serial-number
--------------------------------------------------------------------------------
2
5
If the output of the show card command shows otherwise, enter the show diagnostic ? command to
determine whether or not a hardware failure has occurred. If the output shows a hardware failure, contact
your Cisco technical support representative.
Configuring the Cisco SFS 3504 Server Switch
This section assumes that you have verified the installation. At the end of the verification process, the
Cisco SFS 3504 Server Switch automatically obtains the IP address from Dynamic Host Configuration
Protocol (DHCP) if the DHCP server is configured. This section describes how to configure the
Cisco SFS 3504 Server Switch and includes the following topics:
•
•
•
•
•
•
Cisco SFS 3504 Multifabric Server Switch Installation and Configuration Note
12
admin
fc4port4G
controllerIb12port4xDDR
boot boot
status
done success
done success
product pca
serial-number
JBL07014804 JBL07014804
JAB111902Y9 JAB111902Y9
Obtaining an IP Address from the DHCP Server for Ethernet Management, page 13
Configuring a Static IP Address for Ethernet Management, page 13
Configuring the System Clock, page 17
Configuring an NTP Server, page 18
Launching the Chassis Manager (Optional GUI Interface), page 19
Installing the Element Manager GUI (Optional), page 20
Card Information
oper
type
fc4port4G
controllerIb12port4xDDR
Card Boot Information
boot
image
image-a:SFS_OS-2.10.0/build585
image-a:SFS_OS-2.10.0/build585
Card Seeprom
pca
number
73-11051-02
73-11049-02
admin oper oper
status status code
up up normal
up up normal
fru
number
68-2893-01
68-2890-02
78-18335-01