Table of Contents
Advertisement
.
PRECAUTIONS
WHEN CLEANING:
Never Use a Cleaning or Sanitizing
Solution that has an OIL BASE
(these will dissolve the butyl
sealants) or AMMONIA BASE (this
will corrode the copper components
of the case)
TO PRESERVE THE ATTRACTIVE FINISH:
Do Use Water and a Mild Detergent for
the Exterior Only!
Do Not Use Abrasives or Steel Wool
Scouring Pads (these will mar the finish)
CLEANING GLASS & MIRRORS
Only use a soft cloth and mild glass cleaner for cleaning
any glass or mirrored components. Be sure to rinse
and/or dry completely.
Never use hot water on cold glass surfaces! It
may shatter and cause serious injury! Allow glass
surfaces to warm first.
NON-GLARE GLASS CLEANING
The high optical clarity of this glass is possible due to
special coatings on the glass surface itself. To preserve
this coating and the optical clarity, keep the glass clean.
Windex
®
or Glass Plus
®
mended to be used to clean the non-glare glass. The
damage to the glass from improper, caustic solutions is
ELECTRICAL PRECAUTIONS
Always Disconnect Electrical
Power at the Main Disconnect
when servicing or replacing
any electrical component.
This includes (but not limited to) Fans,
Heaters, Thermostats, and Lights.
REPLACING FLUORESCENT LAMPS
Fluorescent lamps are furnished with a shatterproof
protective coating. The same type of lamp with protec-
tive coating must be used if replaced.
User Information, Cont'd
CLEANING
are the only solutions recom-
BEFORE
SERVICING
irreparable.
In addition to cleaning the glass with the recommended
product, there are precautions that should be taken
when working and cleaning the inside of the case.
• When cleaning the inside of the cases, we recom-
mend that the glass be fully opened and covered to
prevent solutions from splashing onto the glass and
ruining the coating on the inside.
PLEXIGLASS & ACRYLIC CARE
Improper cleaning not only accelerates the cleaning
cycle but also degrades the quality of this surface.
Normal daily buffing motions can generated static cling
attracting dust to the surface. Incorrect cleaning agents
or cleaning cloths can cause micro scratching of the
surface, causing the plastic to haze over time.
CLEANING
Hussmann recommends using a clean damp chamois, or
a paper towel marked as dust and abrasive free with
®
210
Plastic Cleaner and Polish available by calling
Sumner Labs at 1-800-542-8656. Hard, rough cloths or
paper towels will scratch the acrylic and should not be
used.
ANTISTATIC COATINGS
The 210
®
has proven to be very effective in not only
cleaning and polishing the Plexiglass surface, but also
providing antistatic and anti-fog capabilities. This product
also seals pores and provides a protective coating.
Maintenance
U R
T-5 BULBS
Please note: T-5 lights must be turned off and on after
bulb replacement.
EVAPORATOR FANS
The evaporator fans are located between tboth refrig-
eration coils, under the display pans. . Should fans need
16
IGSF-ASC-L / ASCS-L-0308
ENCAPSULITE
SHATTERPROOF COATING - SA 10645
Complies with FDA USDA
R
& OSHA Regulations
for replacement call:
1-800-395-9229
Turn switch off then on after replacing bulb
NSF
Hide quick links:
Advertisement
Table of Contents
