Table of Contents
Advertisement
operation. Equipment such as tackle, hooks, pulley blocks, straps, etc.
should be sized to the winching task and should be periodically inspected for
damage that could reduce their strength.
14. Take appropriate precautions to disable the winch when not in use or
under supervision to prevent use by children or other unauthorized persons.
Do not operate the winch when under the influence of drugs, alcohol or
medication.
15. When moving a load, slowly take up the wire rope slack until it becomes
taut. Stop, recheck all winching connections. Be sure the hook is properly
seated. If a nylon sling is used, check the attachment to the load.
16. When using a winch to move a load, place the vehicle transmission in
neutral, set the vehicle parking brake and chock the wheels.
17. Do not machine or weld any part of the winch. Such alterations may
weaken the structural integrity of the winch.
18. Do not power the winch longer than 120 seconds. The drum and wire
rope/synthetic rope may get too hot
19. Do not connect the winch to either 110C AC house current or 220V mains
as winch burnout or fatal shock may occur. Never allow shock loads to be
applied to the winch or wire rope.
20. Use caution when pulling or lowering a load up and down a ramp or
incline. Keep people, pets and property clear of the path of the load.
INSTALLATION
MOUNTING YOUR WINCH
Please reading and understanding the following prescription:
Step (1)
Choose a mounting location that is sufficiently proper and safe to install
your winch. Pay attention to the different brand and model of the vehicle, the
mounting location may be also different. The safety mounting location must
be plane and the thickness must be at least 0.31inch (8mm).
Do dill four holes which diameter is 10.5mm and position is 152mmX110mm.
(see Figure 7)
10
T-MAX
UTV SERIES
Advertisement
Table of Contents
