Pioneer DDJ-ERGO-V Service Manual page 41

5
[3] CDJ1, CDJ2, CRFD Assemblies and JOG Section
[3-1] Knobs and VRs
(1) Remove the all knobs.
Note: When you remove the knob of the A part,
pull it up to a course directly overhead
necessarily.
(2) Remove the three silider knobs 2,
three slider knobs 1, three stopper/SLD.
(See below.)
The reference of the direction
Side on which
the line reaches the bottom
Stopper
(rear direction)
• Disassembly of the slider knob
The new slider knob adopted by this product is designed so that it is not pulled out easily.
Therefore, the method for removing the slider knob is different from the conventional method; it can only be pulled out after
slider knob 2 is removed.
1 Find the side on which the line reaches
the bottom.
4 Remove the slider knob 1.
Slider knob 1
5
6
1
×30
Stopper
(right direction)
2 Insert a pair of tweezers etc. beneath
the line then push the slider knob 2
upward. To protect the panel from being
scratched, use protective material.
Tweezers
5 Remove the stopper/SLD.
DDJ-ERGO-V
6
7
A
2
×3
Slider knob 2
Protective material
*: During reassembly, fully push
Stopper/SLD
7
8
A
3 Remove the slider knob 2.
Slider knob 2
down Slider knob 2 until it is
dented into Slider knob 1.
8
A
B
C
D
E
F
41