Table of Contents
Advertisement
7. HOW TO WIRE THE ONE-TOUCH CONNECTOR PLUG
This section describes the way to wire the one-touch connector plug.
Refer to the AJ65VBTCU-68ADVN/ADIN Analog-Digital User's Manual
for more information on the types and specifications of the one-touch
connector plugs which conform to the AJ65VBTCU-68ADVN/ADIN.
(1) Cable termination work
Do the following work on the cable terminations of the
communication and analog input cables that are inserted into the
one-touch connector plugs.
1. Cut the sheath.
3. Cut the aluminum tape and braid.
Termination using soldering
Disentangle and twist the shield
and cut them to proper length.
Termination
using soldering
One-touch connector plug for analog
I/O Connect the applicable cable (*1).
*1: For the applicable cable size, refer to the AJ65VBTCU-68ADVN/ADIN Analog-Digital
User's Manual.
Communication cable termination work
DA (Blue)
DB (White)
DG (Yellow)
Drain wire
Analog input cable termination work
V+
V-
SLD
Point
• Where possible, round the tip that was cut with nippers or like.
If the section of the cable to be inserted is not round, the cable may be
caught at any point and not go far enough.
• Do insulation work as necessary on the area of the shield that will not
be inserted into the one-touch connector plug.
2. Separate the shield and drain wire and cut the
shield.
4. Stretch the drain wire and twist it from the base.
(3cm in length, 7 times or more)
3cm
Termination using crimping sleeves
Disentangle and twist the shield
and cut them to proper length.
Termination using
crimping sleeves
Example: Butt joint
17
Drain wire
Shield wire
DA (Blue)
DB (White)
DG (Yellow)
Drain wire (AWG20)
V+
V-
One-touch connector
plug for analog I/O
SLD
Connect the
applicable cable (*1).
Advertisement
Table of Contents
