EAS32883
[C-1] ERASING THE DTC
1. Delete the DTC using the malfunction of the YDT, and check that the MIL goes off.
EAS32884
[C-2] FINAL CHECK
EWA17441
WARNING
When maintenance or checks have been performed on components related to the cruise control
system, be sure to perform a final check before delivering the vehicle to the customer.
1. Check the front brake lever and rear brake pedal operation.
2. Check the rear brake light switch.
Refer to "CHECKING THE SWITCHES" on page 8-53.
3. Execute the diagnostic mode (No. 82 and 83) to check the operation of the front brake light switch,
rear brake light switch, and accelerator position sensor.
Refer to "DIAGNOSTIC CODE: SENSOR OPERATION TABLE" on page 9-76.
4. Execute the diagnostic mode (No. 80 and 81) to check the operation of the cruise control setting
switch.
Refer to "DIAGNOSTIC CODE: SENSOR OPERATION TABLE" on page 9-76.
5. Delete the DTCs.
Refer to "DTC TABLE" on page 9-48.
6. Check the operation of the cruise control system.
Test ride the vehicle and confirm that the cruise control system is operating normally.
CRUISE CONTROL SYSTEM (for MTN890D)
9-34