Quarton ML-400 Instructions

OPERATION FUNCTIONS
Laser aperture
Adjustable bushing
Fixing screw
Screw holes
3 meters Type C to USB cable
OPERATION THE ML-400
1.
Attach the ML-400 to the cutting machine with four M4 screws (screws not included).
2. When in heavy shock/vibration environments, users can place the rubber buffer between bottom
chassis and surface.
3. Eight magnets are installed in the bottom chassis of ML-400. It will have magnetic attraction when it's
on metal surface with iron.
4. Plug in ML-400 with the Type-C to USB Cable, then connect cable to the USB adapter.
5. USB adapter plug in the outlet and turn on the ON/OFF switch.
6. Loose the fixing screw gently and adjust the module housing to project the laser
line into position you want. Tighten the fixing screw to fix the laser's position.
7. Loose the fixing ring. Rotate the adjustable bushing to find the angle you want.
Tighten the fixing ring to fix the laser line's angle.
8. Cut the stuff along the laser line.
ML-400 INSTRUCTIONS
Fixing ring
Module housing
USB adapter
Same as cell phone USB charger
ON/OFF switch
Type C
female connector
Magnets
Bottom Side
Magnets