Electrolux EDE 67550W User Manual page 25

ANTI-KREUK (LONG ANTI-CREASE)
A long anti-crease phase lengthen the anti-
crease phase (30 min.) at the end of the dry-
ing additionally by 60 minutes. The drum ro-
tates at intervals during this phase. This
keeps the laundry loose and free of creases.
Phase lasts in total 90 minutes. The laundry
can be removed at any time during the anti-
crease phase.
When the option is active, the LONG ANTI-
CREASE light is on.
ZOEMER (BUZZER)
When the drying cycle has finished, an inter-
mittent audible signal will sound. By depress-
ing button ZOEMER the acoustic signal is
switched off in the following cases:
• when selecting the programme
• when depressing the buttons
• when the programme selector dial is
turned to another position during the pro-
gramme or when you depress an option
button during the cycle
• at the end of the programme.
The corresponding light comes on.
STARTUITSTEL (DELAY START)
With the STARTUITSTEL button, you
can delay the start of a programme
by 3, 6 or 9 hours.
1. Select the programme and additional
functions.
2. Press the STARTUITSTEL button as
many times as necessary (the lights show
which delay time have been chosen).
3. To activate the delay timer, press button
START/PAUZE. The lights 9h 6h 3h
change on every three hours until the time
is getting on for start cycle.
Starting the programme
Press the START PAUZE (START PAUSE)
button. The programme is started.
The programme phase is shown by appro-
priate lights. From up to the down, from
DROGEN (DRYING) (light 10), LUCHTEN ,
(COOLING) (light 11) to ANTI-KREUK/EINDE
(END) (light 12) .
Changing programme
To change a programme which has been se-
lected by mistake once the programme has
started, first turn the programme selector to
OFF (OFF) position. The programme is can-
celled.
The programme can no longer be
changed directly once the programme
has started. If nevertheless there is an
attempt to change the programme on
the programme knob or if an function
button (excluding the ZOEMER (Buz-
zer) button) is pressed, led START
PAUZE (START / PAUSE) button starts
flashing temporarily in yellow. The drying
programme is not however affected by
this (laundry protection).
Drying cycle complete / removing
laundry
Once the drying cycle is complete, the lights
ANTI-KREUK/EINDE (END) and FILTER are
on. If the buzzer function is active, an acous-
tic signal will sounds intermittently for about
one minute.
The drying cycles are automatically fol-
lowed by an anti-crease phase which
lasts around 30 minutes. The drum ro-
tates at intervals during this phase. This
keeps the laundry loose and free of crea-
ses. The laundry can be removed at any
time during the anti-crease phase. (The
laundry should be taken out towards the
end of the anti-crease phase at the latest
to prevent creases from forming.) If AN-
TI-KREUK (LONG ANTICREASE) func-
tion has been selected, the anti-crease
phase is lengthened by 60 minutes.
1. Open door.
2. Remove laundry.
3. Remove filter after clothes has been re-
moved. Clean the filter.
Warning! Before You place the filter,
please check it there is nothing inside the
filter seat.
4. Turn the programme selector to "O"
(OFF).
Important! Clean the filter after each drying
cycle.
5. Close the door.
electrolux 25