Hoover S3755 Owner's Manual page 8

3-8
Return nozzle to original position and lift
off hood.
3-11
H
If belt is not broken but is stretched or
cut, pull it off the motor pulley (H).
3-14
G
Replace brush roll cover (G) over agita-
tor brush roll. Replace 3 short screws.
8
3-9
G
Remove brush roll cover (G) by remov-
ing the 3 Phillips head screws.
3-12
I
Lift up end of agitator brush roll. Remove
old belt from agitator pulley (I) and
replace with new belt. Lettering on belt
must be visible.
3-15
Position hood on top of nozzle base.
Turn nozzle over. Replace 2 short screws
at the back of nozzle and 2 long screws
at the front.
3-10
G
Lift off brush roll cover (G).
3-13
J
Stretch belt back and attach to motor
pulley.
Hold opposite end of agitator brush roll in
place. Push belt end forward, rotating
end plate (J) until it slides into place.
Turn agitator, making sure it rotates freely.