Carpet Cleaning; Cleaning Tools; Cleaning Stairs; Power Nozzle On/Off - Hoover S3590 Owner's Manual

2-5

Power nozzle ON/OFF

switch
The power nozzle ON/OFF switch (A)
provides power to the nozzle. Push the
switch to the "ON" position for agitator
brush operation, and to turn the head-
light on. Push the switch to the "OFF"
position to stop the brushes, and to turn
the headlight off.
Note: The headlight may be turned off
by the power nozzle ON/OFF switch,
located on the hand grip.

Cleaning tools

The cleaning tools are conveniently
stored on the cleaner.
A tool may be attached to either the
hose or wand by pushing it firmly onto
the hose end or the end of the wand.
Twist tool slightly to tighten or loosen the
connection.
The cleaning tools have many uses.
Select the tool best suited for the clean-
ing task from the following descriptions.
2-8
E
G
Select the proper tool
E. Round swivel brush (stores on
extension wand) may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters and registers. The
head of the brush swivels for use in
hard-to-reach spaces.
F. Upholstery tool (stores on extension
wand) may be used for upholstered fur-
niture, draperies, tapestries, mattresses,
clothing, automobile interiors and car-
peted stairs.
2-6
A
Floor surface
selection

Carpet cleaning

When using the power nozzle for carpet
and rug cleaning, step on the RUG/
FLOOR pedal (D) until the indicator is in
the "RUG" position. This setting provides
the suction and agitator action neces-
sary to deep clean carpets.
G. Crevice tool (stores inside tool lid)
may be used in tight spaces, corners,
and along edges in such places as
dresser drawers, upholstered furniture,
stairs and baseboards.
2-9
F
How to clean stairs
Clean stairs by placing cleaner on end.
Clean stairs from bottom to top.
2-7
D
Hard surface floor
cleaning
The power nozzle can be used for
cleaning hard surface floors such as
wood, linoleum, vinyl, asphalt and rub-
ber tile, sealed cork, concrete and ter-
razzo, as well as carpet.
To set the power nozzle for hard surface
floor cleaning, step on the RUG/FLOOR
pedal placing the indicator in the
"FLOOR" position. This setting provides
suction and no agitator action.
2-10
How to store cleaner
The cleaning tools are conveniently
stored on the cleaner. Open the tool
door (H), located on the cleaner body,
for crevice tool (G) storage.
Place the round swivel brush (E) and the
upholstery tool (F) in the recessed area
on the wand storage clip/tool holder (I),
located on the extension wand.
H
E
F
I
G
Continued
5