Table of Contents
Advertisement
Line Interface Management Modules (LIM)
Upgrade the Image with the CLI
To upgrade the image of the Controller card with the Command Line Interface, refer to
Controller Card with the CLI" on page 57
•
CLI Reference Guide
Upgrade the Image with the Chassis Manager
To upgrade the system image with the Chassis Manager web GUI, refer to the following document:
•
Chassis Manager User Guide
Upgrade the Image with the Element Manager
To upgrade the system image with the optionally licensed Element Manager GUI, refer to the following
documents:
•
Element Manager User Guide
About LIM Cards
Refer to
"Line Interface Modules (LIM)" on page 19
About a Failed LIM Module
If you believe a line interface module has failed, contact technical support.
Refer to
"LIM Status LEDs" on page 75
information.
Locating a Failed LIM Module
The Line Interface Management modules are located on the back of the chassis. Refer to
a diagram of the chassis.
Removing a LIM Card
1.
Ground yourself appropriately.
2.
Verify that you have a means of covering the slot before removing the module. Do not remove the
module unless you have a replacement or a blanking panel for the slot, as overheating may occur.
and the following document:
for specific information about the LIM modules.
and
"Monitor the Cards" on page 79
45
"Upgrading a
for monitoring
Figure 1-2
for
Advertisement
Table of Contents
