Table of Contents
Advertisement
SPECIFICATIONS
2.
Place the stop switch in the "OFF" position.
3.
Remove accumulation of grease, oil, dirt and debris from exterior of
unit.
4.
Perform all periodic lubrication and services that are required.
5.
Tighten all the screws and nuts.
6.
Drain fuel tank completely. Press purge bulb 6 - 7 times to remove
remaining fuel from carburetor then drain the tank again. Close choke,
start and run the engine until it stops due to lack of fuel.
7.
Allow engine to cool. Remove the spark plug lead from the spark plug.
Remove the spark plug. Pour 7 cc (0.25 oz.) of fresh, clean, two-stroke
engine oil into the cylinder through the spark plug hole.
8.
Pull the recoil starter handle 2 - 3 times to distribute the oil inside the
engine.
9.
Observe the piston location through the spark plug hole. Pull the recoil
handle slowly until the piston reaches the top of its travel and leave it
there.
10. Install the spark plug. Connect the spark plug lead to the spark plug.
SPECIFICATIONS
MODEL
Length
Width
Height
Weight (dry) without Cutter
Head
Engine Type
Bore
Stroke
Displacement
Exhaust
Carburetor
Ignition System
Spark Plug
Fuel
36
1370 mm (53.9 in.)
315 mm (12.4 in.)
540 mm (21.3 in.)
4.3 kg (9.48 lb.)
Air cooled, two-stroke, single cylinder gasoline
engine
32.2 mm (1.27 in.)
26.0 mm (1.02 in.)
21.2 cm³ (1.29 in.³)
Spark arrestor muffler or spark arrestor muffler with
catalyst
Diaphragm with purge pump
Flywheel magneto, capacitor discharge ignition type
NGK BPM8Y (Canada NGK BPMR8Y)
Gap 0.65 mm (0.026 in.)
Mixed (Gasoline and Two-stroke Oil)
GT-225i
X7732274600
© 10/2017 ECHO Inc.
GT-225I
Advertisement
Table of Contents
