Using Your Door Operator - Chamberlain LJ8950W Manual

Operation

Using Your Door Operator

FEATURES
Your door operator is equipped with
features to provide you with greater control
over your door operation.
myQ
myQ allows you to control your door
operator from your mobile device or
computer from anywhere. myQ technology
uses a 900Mhz signal to provide two way
communication between the door operator
and myQ enabled accessories. The door
operator has an internal gateway that
allows the door operator to communicate
directly with a home Wi-Fi network and
access your myQ account.
THE PROTECTOR SYSTEM (SAFETY
REVERSING SENSORS)
When properly connected and aligned,
the safety reversing sensors will detect
an obstruction in the path of the infrared
beam. If an obstruction breaks the infrared
beam while the door is closing, the door
will stop and reverse to full open position.
If the door is fully open, and the safety
reversing sensors are not installed, or are
misaligned, the door will not close from
a remote control. However, you can close
the door if you hold the button on the door
control or keyless entry until the door is
fully closed. The safety reversing sensors
do not affect the opening cycle. For more
information see page 13.
MEMORY CAPACITY
SECURITY+ 2.0 ACCESSORIES
®
Remote Controls
Keyless Entries
myQ Accessories
USING YOUR DOOR OPERATOR
The door operator can be activated through
a wall-mounted door control, remote
control, wireless keyless entry or myQ
accessory. When the door is closed and
the door operator is activated the door will
open. If the door senses an obstruction
or is interrupted while opening the door
will stop. When the door is in any position
other than closed and the door operator
is activated the door will close. If the door
operator senses an obstruction while
closing, the door will reverse. However,
you can close the door if you hold the
button on the door control or keyless entry
until the door is fully closed. The safety
reversing sensors do not affect the opening
cycle. The safety reversing sensor must
be connected and aligned correctly before
the door operator will move in the down
direction.
BATTERY BACKUP (OPTIONAL)
The battery backup system allows access
in and out of your building, even when
the power is out. When the door operator
is operating on battery power, the door
operator will run slower, the Battery Status
LED will glow solid orange, and a beep will
sound approximately every 2 seconds.
MEMORY CAPACITY
Up to 40
Up to 4
Up to 16
24