Table of Contents
Advertisement
Operating mode
This appliance can be used in air extraction mode.
Exhaust air mode
The air which is drawn in is cleaned by the
grease filters and conveyed to the exterior
by a pipe system.
Operating the appliance
Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Controls
Use the toggle switches to set and adjust the various different
functions of your appliance.
Extractor hood
Switches on power setting 1
ü
Switches off the extractor hood
Þ
Lighting
Switches on/off the lighting
[
Note: The air must not be discharged into a flue that is used for
exhausting fumes from appliances burning gas or other fuels
(not applicable to appliances that only discharge the air back
into the room).
Before conveying the exhaust air into a non-functioning smoke
or exhaust gas flue, obtain the consent of the heating engineer
responsible.
Filter drawer
Pulling out the filter drawer
Hold the filter pull-out in the middle and pull it out.
You can now access the controls and the appliance is ready for
operation.
Note: The appliance starts with the functions that were set
when the pull-out was closed.
Pushing the filter drawer in
Hold the filter pull-out in the middle and push it in.
Note: The extractor hood and the lighting will switch off when
the pull-out is closed.
Switching on the extractor hood
Switching on
Set the toggle switch to
ü
.
Note: It can take up to 25 seconds for the backflow preventer
valve to open fully and for the appliance to reach its full
capacity.
Switching off
Set the toggle switch to
Þ
Lighting
The lighting will work even if the extractor hood is switched off.
Switching on
Move the toggle switch to the left.
Switching off
Move the toggle switch to the right.
.
5
Advertisement
Table of Contents
