Step 5: Connectors; Step 6: Complete Physical Installation - IBM Deskstar 22GXP Installation Manual

IBM storage products

Step 5: Connectors

After the drive has been carefully mounted, connect the IDE cable (included) and the power cable to the
drive. If you are using a cable already installed in your computer, ensure that the cable length does not
exceed 18 inches (45.7 cm). (Note that the IDE connector and power connector are keyed for proper
insertion.)
Interface Connector
Power Connector
Jumper Block
Connector locations

Step 6: Complete physical installation

Plug the cable into the onboard port. If you have added an Ultra ATA/66 controller card plug the cable
into the controller. The figure below shows the possible location of the onboard ports. Each port is
marked on the motherboard.
Page 12
IBM Hard Disk Drive Technical Support Center version 1.0