JVC LT-50E340 Instructions Manual page 13

Connections to other equipment
Using an AV Amplifier with built-in digital surround
If you are using an AV Amplifier with built-in digital surround sound, you can enjoy various audio systems
including Dolby Digital Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, DTS decoder, or MPEG decoder etc. as
shown below.
Right of the unit
To COAXIAL OUT
Coaxial digital cable
(not supplied)
To Coaxial
Digital Audio Input
AV Amplifier with built-in digital surround decoder
NOTE:
• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio.
There will be no sound output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder.
To connect a HDMI or a DVI device to the unit
The HDMI input receives digital audio and uncompressed video from a HDMI device or uncompressed digital
video from a DVI device.
When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only video signal. Separate
analog audio cords required.
Rear and right of the unit
NOTE:
• The audio output from the devices connected by HDMI may not output the sound from the audio output jacks
of this unit for copyright protection. In details, please check the table below.
Content
SACD/DVD-Audio
Others
* Depening on devices, the sound may not be output.
HDMI cable (type A connector)
To HDMI/DVI IN
HDMI - to - DVI adapter cable
(HDMI type A connector)
(not supplied)
Audio cord (not supplied)
To AUDIO IN
Audio Out
Digital
Prohibited
Prohibited
Front
Speaker
(Left)
To HDMI output
(not supplied)
To DVI output
Analog
Available*
Prohibited
Subwoofer
TV
Center Speaker
Surround
Speaker (Left)
HDMI device
or
DVI device
Front
Speaker
(Right)
Surround
Speaker
(Right)
13 EN