Correcting The Keystone Distortions; Using The Magnify Feature - Hitachi CP-X201 User Manual – Operating Manual

Correcting the keystone distortions

1.
Press KEYSTONE button on the remote
control. A dialog will appear on the screen to
aid you in correcting the distortion.
2.
Use the ▲/▼ cursor buttons to select AUTO or MANUAL
operation, and press the ► button to perform the
following.
(1) AUTO executes automatic vertical keystone correction.
(2) MANUAL displays a dialog for keystone correction.
Use the ▲/▼ buttons for adjustment.
To close the dialog and complete this operation, press KEYSTONE button again. Even
if you do not do anything, the dialog will automatically disappear after a few seconds.
● The adjustable range of this correction will vary among inputs. For some input, this function may not work well.
● When V:INVERT or H&V:INVERT is selected to the MIRROR item in the SETUP menu, if
the projector screen is inclined or angled downward, this function may not work correctly.
● When the zoom adjustment is set to the TELE (telephoto focus), the automatic keystone
distortion correction may be excessive. This function should be used when the zoom
adjustment is set to the full WIDE (wide-angle focus) whenever possible.
● When the projector is placed on the level (about ±3°), the automatic keystone distortion correction may not work.
● When the projector is inclined to near ±30 degree or over, this function may not work well.
● This function will be unavailable when Transition Detector is on (49).

Using the magnify feature

1.
Press the ON button of MAGNIFY on the remote control.
The "MAGNIFY" indication will appear on the screen and the
projector will go into the MAGNIFY mode. When the ON button of
MAGNIFY is pressed first after the projector is started, the picture
will be zoomed twice. The indication will disappear in several
seconds with no operation.
2.
Use the ▲/▼ cursor buttons to adjust the zoom level. The picture of
video, s-video or component video signal can be zoomed in up to 2
times, and the one of computer signal can be zoomed in up to 4 times.
To move the zoom area, press the POSITION button in the MAGNIFY mode, then use
the ▲/▼/◄/► cursor buttons to move the area. And to finalize the zoom area, press
the POSITION button again.
To exit from the MAGNIFY mode and restore the screen to normal, press the OFF
button of MAGNIFY on the remote control.
● The projector automatically exits from the MAGNIFY mode when the input signal is
changed or when the display condition is changed.
● In the MAGNIFY mode, the keystone distortion condition may vary, it will be restored
when the projector exits from the MAGNIFY mode.
NOTE
• The zoom level can be finely adjusted. Closely watch the screen to
find the level you want.
Operating
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
KEYSTONE button
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON
MUTE
1 2
POSITION MENU
ENTER
ESC RESET
MAGNIFY
ON/OFF button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
AUTO
ASPECT SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
POSITION MENU
ENTER
ESC RESET
9