Operation; Bevel Cutting - Makita M4301 Instruction Manual

OPERATION

Always hold the base flush with
CAUTION:
the workpiece. Failure to do so may cause jig saw
blade breakage, resulting in a serious injury.
CAUTION:
Advance the tool very slowly when
cutting curves or scrolling. Forcing the tool may
cause a slanted cutting surface and jig saw blade
breakage.
1
Fig.6
► 1 . Cutting line 2. Base
Turn the tool on without the jig saw blade making any
contact and wait until the blade attains full speed. Then
rest the base flat on the workpiece and gently move the
tool forward along the previously marked cutting line.

Bevel cutting

CAUTION:
Always be sure that the tool is
switched off and unplugged before tilting the
base.
CAUTION:
Raise the dust cover all the way
before making bevel cuts.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Fig.7
Loosen the bolt on the back of the base with the hex Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in wrench. Move the base so that the bolt is positioned in
the center of the cross-shaped slot in the base. the center of the cross-shaped slot in the base.
Fig.8
► 1 . Hex wrench 2. Bolt 3. Base
Tilt the base until the desired bevel angle is obtained.
The edge of the motor housing indicates the bevel
angle by graduations. Then tighten the bolt to secure
the base.
2
Fig.9
► 1 . Edge 2. Graduation
Front flush cuts
Fig.10
► 1 . Hex wrench 2. Bolt 3. Base
Loosen the bolt on the back of the base with the hex Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then wrench and slide the base all the way back. Then
tighten the bolt to secure the base. tighten the bolt to secure the base.
6 ENGLISH 6 ENGLISH
1
2
3
1
2
1
2
3