Table of Contents
Advertisement
12. Remove the flare nuts from the connections on the
unit and discard the seal from each of the piping
connections.
13. Slide the flare nuts onto the ends of the field-provided
refrigerant piping before using a suitable flaring tool to
flare the end of the copper pipe.
14. Apply recommended HFC-410A refrigerant lubricant to
the outside of the flared refrigerant lines.
IMPORTANT
The
compressor
in
oil
(Polyvinylether).
hydrofluorocarbon (HFC) refrigerants, such as HFC-
410A, which this system contains. While it may have
some miscibility properties with mineral-based oil and
POE oil (Polyolester), it is not recommended to mix PVE
oil with any other type of refrigerant oil.
15. Align the threaded connections with the flared refrigerant
lines. Tighten the flare nuts lightly at first to obtain a smooth
match as illustrated in "Figure 25. Making Connections
(Male to Female Connection)".
Table 3. Refrigerant Piping and Indoor Unit
Connection Sizes
Size
Liquid Line
(Btuh)
36000
A
B
Figure 25. Making Connections
(Male to Female Connection)
this
unit
contains
PVE
oil
is
formulated
Suction Line
in.
in.
3/8
5/8
CANT ON THE OUTSIDE OF
THE FLARE
MALE FLARE
CONNECTION
16. Once snug, continue another half-turn on each nut
which should create a leak-free joint. A torque wrench
may be used to tighten flare nuts using "Table 4. Flare
Nut Torque Recommendations". Do not over-tighten
a flared joint. Flared connections should always
be accessible and must be insulated to prevent
condensation.
17. After refrigerant piping has been installed and checked
for leaks, apply insulation over all flared connections.
PVE
Always use two wrenches when tightening flare nuts to
for
avoid twisting refrigerant piping. DO NOT over-tighten
flare nuts.
TO INDOOR
UNIT
Table 4. Flare Nut Torque Recommendations
Outside
Diameter
Inches
3/8
5/8
14
IMPORTANT
TORQUE WRENCH
TO OUTDOOR UNIT
Figure 26. Tighten Flare Nut
No torque wrench available
Recommended
Finger tighten and use an
Torque
appropriately sized wrench to
turn an additional:
26 ft.-lb. (35 N)
48 ft.-lb. (65 N)
BACKUP
WRENCH
1/2 turn
1 full turn
Advertisement
Table of Contents
