Hauppauge WinTV-PVR-150 Kit Quick Installation Manual page 3

/500MCE via the white and red audio input jacks.
Step 2: Installing the WinTV-PVR-150/500 Media Center driver
After installing the WinTV-PVR in your
PC, boot Windows. The Found New
Hardware Wizard will appear. Insert
the WinTV-PVR MCE Driver
Installation CD-ROM in your PC's
CD-ROM drive.
Click No, not at this time.
Click Next.
Make sure Install the software
automatically (Recommended) is
checked. Click Next.
If the Hardware Installation dialog box opens, click Continue Anyway.
Click Finish.
If you are installing the dual tuner WinTV-PVR-500MCE, you will see the
Found New Hardware message for the second TV tuner. Follow these steps
for the second TV tuner.
Step 3. Install the Media Center Remote control
The Media Center remote control receiver is a USB device which both
receives remote control commands and also transmits commands via an IR
Blaster to a set top box to change channels.
To install the Media Center remote control, simply plug it into any USB port. To
test the Media Center remote, click the Start button in the middle of the remote
control. Media Center should open.
If you have a satellite set top box and would like the Media Center remote
control receiver to change channels, plug one end of the IR Blaster cable
into the Media Center remote control receiver and position the other end
(the transmitter end) over the IR receiver on your set top box.
TV set up under Media Center Edition
To manually launch Media Centers TV Set Up Wizard, in the main Media
Center menu go to Settings / TV / Set up TV Signal.
You will see a message: Set Up Your TV Signal. Click Next.
In Confirm your Region, make sure your region is selected. Click Next.
You will see Automatic TV Signal Setup. We recommend selecting
Configure my TV signal automatically. Click Next.
N
at this point, Media Center Edition will set up the TV tuner. This might
ote:
take a minute or so.
You will then see a message saying Examining your TV signal. Media Center
is determining the type of TV connection you have. When it is finished, it will tell
you whether you have a cable TV, antenna or set top box connection.
3