Hatco PMGH-60 Installation, Operating, Service And Parts Manual
Hatco PMGH-60 Installation, Operating, Service And Parts Manual

Hatco PMGH-60 Installation, Operating, Service And Parts Manual

Accessory flue gas hood

Advertisement

Quick Links

Installation, Operating, Service and Parts Manual For:
WATER HEATERS FOR OTHER THAN RECREATIONAL VEHICLE
CHAUFFE-EAU POUR INSTALLATION AUTRE QUE DANS DES VÉHICULES DE
WARNING: If the information in these
instructions is not followed exactly, a
fire or explosion may result causing
property damage, personal injury or
death.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your
building.
• Immediately call your gas supplier
from a neighbor's phone. Follow
the gas supplier's instructions.
• If you cannot reach your gas
supplier, call the fire department.
• Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
Accessory Flue Gas Hood
Model: PMGH-60
I&W #07.05.054.00
INSTALLATION ONLY
LOISIR UNIQUEMENT
AVERTISSEMENT: Assurez-vous de
bien suivre les instructions données
dans cette notice pour réduire au
minimum le risque d'incendie ou
d'explosion
ou
dommage matériel, toute blessure ou la
mort.
Ne pas entreposer ni utiliser d'essence
ou ni d'autres vapeurs ou liquides
inflammables
à
appareil ou de tout autre appareil.
QUE FAIRE SI VOUS SENTEZ UNE
ODEUR DE GAZ:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur; ne
pas vous servir des téléphones se
trouvant dans le bâtiment.
• Appelez immediatement votre
fournisseur de gaz depuis un voisin.
Suivex les instructions du
fournisseur.
• Si vous ne pouvez rejoindre le
fournisseur, appelez le service des
incendies.
• L'installation et l'entretien doivent être
assurés par un installateur ou un
service d'entretien qualifié ou par le
fournisseur de gaz.
pour
éviter
tout
proximité
de
cet

Advertisement

Table of Contents
loading

Summary of Contents for Hatco PMGH-60

  • Page 1 • If you cannot reach your gas supplier, call the fire department. • Installation and service must be performed by a qualified installer, service agency or the gas supplier. Model: PMGH-60 I&W #07.05.054.00 INSTALLATION ONLY LOISIR UNIQUEMENT AVERTISSEMENT: Assurez-vous de bien suivre les instructions données...
  • Page 2: Table Of Contents

    (identification plate located on the lower right hand side, front corner of the unit), voltage and purchase date of your PMGH-60 Accessory Flue Hood in the spaces below. Please have this information available when calling Hatco for service assistance.
  • Page 3: Model Description

    (6 m) away from the unit. NOTE: One elbow equals 5 linear feet (1.5 m). All Hatco booster heater accessories are warranted to be free of defects in material and workmanship under normal use and service, and when installed in accordance with factory recommendations.
  • Page 4: Specifications

    SPECIFICATIONS Type: Accessory Hood Exhaust Fan. Power: Supply 120 VAC, 18 watt, 1 amp. Dimensions: 24-3/8" wide, 15-1/2" deep, 6-7/8" high (619 x 394 x 175 mm). Adding 5-7/8" (149 mm) to height and 4" (102 mm) to width. Weight: 10 pounds (5 kg).
  • Page 5: Installation

    1. Place the unit (with the 4" [102 mm] diameter flue adapter facing toward the rear) directly on top of the Hatco PMG-60 Gas Booster Heater, nesting the assembly with the brackets inside of the Auxiliary Hood. 2. Connect 4" (102 mm) diameter flue pipe to the adapter to direct the flue gas up to 20 linear feet (6 meters) away from the unit.
  • Page 6: Electric

    Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to use Hatco Replacement...
  • Page 7: Hatco Limited Warranty

    Hatco reserves the right to accept or reject any such claim in whole or in part. Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer’s sole expense.
  • Page 8: Authorized Parts Distributors

    Cone’s Repair Service Flanders Moline 309-797-5323 P.O. Box 340500, Milwaukee, WI 53234-0500 U.S.A. Parts & Service Fax (800) 690-2966 Printed in U.S.A. April 2005 HATCO AUTHORIZED PARTS DISTRIBUTORS NEW YORK Acme American Repairs, Inc. 317-545-9655 Brooklyn Alpro Service Co. Brooklyn...

Table of Contents