Before Operating - Frigidaire GMOS1962AF Use & Care Manual

BEFORE OPERATING

1.Before operating your new oven make sure you read
and understand this Use and Care Guide completely.
2.Before the Built-in Convention Microwave Oven
can be used, follow these procedures:
• Plug in the oven. Close the door. The oven display
will flash 12:00 ENTER TIME.
• If no operation after 1 minute, the oven will show
12:01.
3. Set clock. See below.
Setting the clock
Example: setting clock display for 9:00:
1. Touch p a d once .
2. Enter time using number pads.
3. Touch START p ad .
Setting the clock ON/OFF
Example: to turn off clock display:
1. Touch and hold pad .
2. Time will display, after 3s, OFF
will display.
Example: to turn on clock display:
1. Clock key (short press <1sec) to enter the
clock query state, display "current clock" for 3
seconds and then return to standby mode, the
clock is not displayed;
Hold Clock button 3s, at beginning, clock
2.
will be displayed then display ON, then
display clock again.
10
Setting the timer
Example: setting timer for 5 minutes:
1. Touch Timer pad once.
2. Enter desired time using number pads.
3. Touch Timer pad.
Timer count down does not stop even if the door is opened.
To stop/cancel the timer, press the
When the timer has reached the end of set time, you will
hear beep alerts indicating the timer has run out.
Exhaust High / Med / Low / Off
The exhaust ventilation removes steam and other cooking
vapors from the cooking surface of the range below the
microwave oven.
To operate the exhaust vent, touch the
Exhaust High/Med/Low/Off
highest speed setting. Touch the pad again to
choose the Med speed setting, a 3rd time to
choose the Low speed setting and a four times
to turn the exhaust ventilation off.
Note: If the temperature gets too hot around the microwave
oven, the fan in the exhaust vent hood will automatically turn
on at the LOW setting to cool the oven. The fan will
OFF
automatically turn off when the internal parts are cool. When
this occurs, the vent cannot be turned off.
Surface Light High / Low / Off
Touch the
once to activate the surface light, the screen
= d isplays "HIGH". Continue to touch the
Surface Light High/Low/Off
choose the LOW or OFF gear.
Timer
pad once for the
Surface Light High/Low/Off
pad, you can
key once .
pad