NaviLite N3 Series Installation Instructions

Exit and Emergency Lighting
FOR EMERGENCY LIGHTING UNITS WITH SELF DIAGNOSTICS –
N3 SERIES
SAVE THESE INSTRUCTIONS
IMPORTANT SAFEGUARDS:
When using electrical equipment, always adhere to basic safety precautions including the following:
IMPORTANT
The battery in this unit may not be fully
charged. After electricity is connected
to unit, let battery charge for at least 24
hours, then normal operation of this unit
should take effect. To check, press the
TEST button. The emergency lamps
should illuminate.
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. Do not use outdoors.
2. Equipment should be mounted
securely in locations and at heights
where it will not be readily subjected
to tampering by unauthorized
personnel.
3. Do not mount near gas or electric
heaters.
4. Cap unused wires with enclosed wire
nuts or other approved method.
5. Do not use this equipment for
anything other than its intended use.
6. The use of accessory equipment not
recommended by the manufacturer
will void product listing and warranty
and may cause an unsafe condition.
7. Disconnect AC power before servic-
ing and installation.
8. Use caution when servicing batteries.
9. Any service on this equipment should
be performed by qualified personnel
only.
10. Make sure wire terminations are
secure and leads are properly
tucked in appropriate wire channels.
FIG. 1
INSTALLATION INSTRUCTIONS
INSTALLATION (WALL MOUNTING)
1. Feed fixture leads through back plate
and connect to AC power supply
(Fig. 1).
2. Connect wires through J-Box. Mount
back plate on J-Box and secure with
screws.
3. Connect battery (Fig. 2).
4. Align snaps and push housing directly
onto main bottom case (Fig. 3). Apply
continuous AC power and press TEST
button to check operation.
PLUG IN
FIG. 2
PULL BACK THE PROTECTIVE SLEEVE
INSTALLATION (FLEX CONDUIT)
1. Secure back plate to wall surface.
Route wires through hole in conduit
flange, secure conduit and connect to
AC power supply.
2. Connect battery (Fig. 2).
3. Align snaps and push housing directly
onto back plate (Fig. 3). Apply
continuous AC power and press TEST
button to check operation.
FLEXIBLE CONDUIT ONLY
FIG. 3
(Continued on back) pg 1 of 2