Installing The Ni 5663E - National Instruments PXIe-5663E Getting Started

If the installation window does not appear, navigate to the drive, double-click
it, and double-click autorun.exe.
3. Follow the instructions in the installation prompts.
Note
installation. Accept the prompts to complete the installation.
4. When the installer completes, select Restart in the dialog box that prompts
you to restart, shut down, or restart later.

Installing the NI 5663E

Caution
To prevent damage to the NI 5663E caused by ESD or
contamination, handle the module using the edges or the metal bracket.
1. Ensure the AC power source is connected to the chassis before installing the
module.
The AC power cord grounds the chassis and protects it from electrical damage
while you install the module.
2. Power off the chassis.
3. Inspect the slot pins on the chassis backplane for any bends or damage prior
to installation. Do not install a module if the backplane is damaged.
4. Remove the black plastic covers from all the captive screws on the module
front panel.
5. Identify a supported slot in the chassis. The following figure shows the
symbols that indicate the slot types.
Windows users may see access and security messages during
PXIe-5663E Getting Started
© National Instruments
9