Harman Kardon AVR 435 Owner's Manual page 31

level settings by using either the Input Source
Selectors 7 on the front panel or the buttons
on the remote that are used to select an input
source d ç∂. Next, return to the
CHANNEL OUTPUT submenu using the steps
outlined above.
At the CHANNEL OUTPUT menu press
Navigation Button o until the cursor is
⁄ / ¤
pointing to the LEVEL TRIM line and then
Navigation Button o once so
press the /
⁄ ¤
that INDEPENDENT appears in highlighted
video. When this setting is active you may change the
channel output levels for any input without changing
the settings previously established for another.
To return to the settings established by EzSet/EQ,
even if you have made manual changes to the output
trims using the steps shown above, press
Navigation Button o so that the cursor is pointing
to the EZSET SETTINGS line and then
Navigation Button o once so
press the /
⁄ ¤
ON appears in highlighted video. Remember that
after turning the EzSet/EQ settings back on you must
turn return to this menu line and change the setting to
OFF if you wish to make any manual trim adjust-
ments.
When all changes to the Channel Output levels and
the associated level trim settings have been made
Navigation Button o until
press the /
⁄ ¤
the cursor is on the BACK TO MANUAL
SETUP menu and then pressing the Set Button
q so that you may make any other adjustments to
the system parameters. If the changes just made com-
plete the manual adjustments needed, press the OSD
Button to exit the menu system and resume
normal system operation.
Additional Input Adjustments
After one input has been adjusted for Surround mode,
digital input (if any), speaker type, and output levels,
go back to the INPUT SETUP line on the
MASTER MENU (Figure 1) and enter the set-
tings for each input that you will use. In most cases,
only the digital input and surround mode will be differ-
ent from one input to the next, while the speaker type,
crossover frequency, Night mode and output level
settings will usually be the same and may be quickly
entered by entering the same data used for the
original input.
Once the settings outlined on the previous pages have
been made, the AVR 435 is ready for operation. While
there are some additional settings to be made, these
are best done after you have had an opportunity to lis-
ten to a variety of sources and different kinds of pro-
gram material. These advanced settings are described
on pages 39 and 40 of this manual. In addition, any
of the settings made in the initial configuration of the
unit may be changed at any time. As you add new or
different sources or speakers, or if you wish to change
a setting to better reflect your listening taste, simply
follow the instructions for changing the settings for that
parameter as shown in this section.
Having completed the setup and configuration process
for your AVR 435, you are about to experience the
finest in music and home theater listening. Enjoy!
⁄ / ¤
SYSTEM CONFIGURATION SYSTEM CONFIGURATION
SYSTEM CONFIGURATION SYSTEM CONFIGURATION 31 31