Pyle PACGAMP77 User Manual

15 Watt Acoustic Guitar Amplifier
8'' Speaker with Volume, Bass, Treble, Gain,
Drive Switch and Digital Reverb Controls
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Before going any further, make sure that your ampli er is compatible
with your mains electricity supply.
1. Ensure that the MAINS (power) switch is set to the OFF position.
2. Connect the supplied mains (power) lead into the mains electricity supply.
3. Ensure that the VOLUME controls are set to zero.
4. Plug your guitar into an INPUT jack socket.
5. Turn the front panel MAINS switch to the ON position.
6. Turn the VOLUME up to your preferred level and your ampli er is ready to play.
Function
1
1. INPUT: Input for your guitar. Use a good quality guitar cable (i.e. one that's
screened/shielded) to help prevent noise, interference and unwanted feedback.
2. VOLUME: This is the overall level control for the normal channel.
3. TREBLE: Increasing the Treble will make your sounds brighter and more cutting,
turning it down will decrease your tone's edge and make it sound softer as a result.
4. MIDDLE: Adjusts the sound level of middle-frequency range.
5. BASS: Adjusts the sound level of the low-frequency range.
6. CHORUS CONTROL: Rotating this control clockwise increases the modulation
rate of the chorus e ect.
7. PHONES: Connect headphones to this jack.
8. POWER: The power switch turns your ampli er on and o .
*No sound is played through the unit s speaker while the PHONES jack is in use.
www.PyleUSA.com
2 3 4 5 6 8
7