SAFETY INSTRUCTIONS UNPACKING Thank you for choosing our LEDSPOT 300 with linear motorized zoom from 12° to CAUTION 36°. For your own safety, please read this manual before installing the device. This Becareful with your operations.With a dangerous voltage you cansuffer a manual covers the important information on installation and applications.
Specifications FEATURES & SPECIFICATIONS Input Voltage: AC90-260V 50/60Hz LED Quantities: 1*300W white LED lamp Features Control Signal: DMX512, master-slave and sound activated or auto operation • A 300W single white LED lamp Control Channel: 17/15/17 DMX channels USITT DMX-512 • 50000 hours life span and low power consumption Power Consumption: •...
properly when installing the fixture. PHOTOMETRIC DATA · Make sure the lens are in good condition. It’s recommended to replace the units if there are any damages or severe scratch. Photometric Beam Angle Data 12°~36°Beam Angle LUX × 0.0929=FC · Make sure the fixture is operated by qualified personnel who knows the fixture 1875 / 20180 480 / 5250 223 / 2400...
DMX-512 CONTROL CONNECTIONS main power cord to the appropriate wall outlet. Clamp Mounting: The LEDSPOT 300 provides two unique mounting bracket assembly that integrates the bottom of the base, the included “Omega Bracket,” and Connect the provided XLR cable to the female 3-pin XLR output of your controller the safety cable rigging point in one unit (see the illustration below).
For installations where the DMX cable has to run a long DMX CHANNELS distance or is in an electrically noisy environment, such as 120 Ω in a discotheque, it is recommended to use a DMX terminator. This helps in preventing corruption of the Mode/Channel Function Values Description...
Page 7
040-049 Gobo 4 224-255 Shutter open 050-059 Gobo 5 Dimmer 0-255 0-100% Linear dimmer 060-069 Gobo 6 Focus 0-255 In(near) to out(far) 070-079 Gobo 7 Zoom 0-255 In(near, 12°) to out(far, 36°) 080-099 Gobo 1 shake slow to fast Rotating 0-005 100-119 Gobo 2 shake slow to fast...
MAINTENANCE AND CLEANING The following points have to be considered during the inspection: 1) All screws for installing the devices or parts of the device have to be tightly connected and must not be corroded. 2) There must not be any deformations on the housing, color lenses, fixations and installation spots (ceiling, suspension, trussing).