Page 3
Safety Information (continued) COOKING SAFETY INFORMATION WARNING: To reduce the risk of fire, use only metal duct work . Never use plastic duct work . 1 . Never leave the range hood unattended when in use . 2 . Never cook over open flames under the range hood. WARNING: To reduce the risk of fire or electric shock, do 1 .
Warranty ONE YEAR LIMITED WARRANTY A thorough inspection must be made before installation and any damage must be promptly reported . We will not be liable for failures or damage that could have been discovered or avoided by proper inspection and testing prior to installation . Conglom Kitchen &...
Pre-Installation (continued) PACKAGE CONTENTS Part Description Quantity Range hood Aluminum & charcoal filter Rectangular damper (located inside the hood) Round adapter (located inside the hood) HARDWARE INCLUDED NOTE: Parts not shown in actual size. Part Description Quantity Long tapping screws (ST4x18mm) Short tapping screws (ST4x10-F-Hmm) Wire Connectors Washer...
Pre-Installation (continued) PLANNING INSTALLATION Number of people required: 2 or more WARNING: Always wear safety goggles and gloves during Carefully check the range hood for damage and for missing parts installation . prior to installation . If there is any damage or if you are missing parts, do not proceed with the installation .
Page 8
Pre-Installation (continued) FOLLOW THESE GUIDELINES WHEN INSTALLING DUCT WORK: - Your venting system must vent to the outdoors either horizontally through the back wall (13) or vertically through the roof (14) (refer to Fig . 5/Fig . 6/Fig . 7) . - Use round metal duct work with a uniform diameter of 177 mm (7 in) .
Page 9
Pre-Installation (continued) WIRING CONNECTION REQUIREMENTS DANGER: Risk of electrical shock . This range hood must Installation work and electrical wiring must be done by a qualified be properly grounded . person(s) in accordance with all applicable codes and standards, including fire-rated construction. DANGER: Turn off the power circuit breaker or the power switch on the junction box before installing this...
Installation REMOVING THE ELECTRICAL KNOCK-OUT HOLE REMOVING THE VENTING HOLE (FOR EXTERIOR VENTING) - Choose the venting hole to remove for your installation WARNING: Always wear safety goggles and gloves during type . Use the top holes (3 & 4) for a top venting installation .
Page 11
Installation (continued) INSTALLING THE CHARCOAL FILTER (SKIP THIS STEP IF YOU ARE USING EXTERIOR VENTING) NOTE: The charcoal filter should only be installed if you are not using an external venting system. - Turn the filter clip to either side and lift the aluminum filter. - Place the charcoal filter (B) in place, ensure that it covers the air outlet entirely.
Page 12
Installation (continued) INSTALLING THE RANGE HOOD DANGER: Turn off the power circuit breaker or the power switch on the junction box before installing this unit . Touching circuitry inside the range hood while it is energized will result in death or serious injury . DANGER: If installing this unit over a gas range, turn off the gas at the source before installing or servicing this unit .
Operation NOTE: The fan and lights operate independently of each other. TURNING ON/OFF THE UNIT TURNING ON/OFF THE LIGHTS - To turn on the fan, press the appropriate speed control - Press the light switch (1) to turn on the lights . switch [Low Speed (3), High Speed (2)] to select the desired level of power .
Maintenance REPLACING FILTER DANGER: Turn off the power circuit breaker or the power switch on the junction box before performing maintenance . Touching circuitry inside the range hood while it is energized When filter need replacing, exchange with similar. Also replace will result in death or serious injury .
Care and Cleaning RANGE HOOD WARNING: Failure to maintain basic standards of care and cleaning of the range hood will increase the risk of fire. The range hood should be cleaned (regularly internally and externally) to preserve its appearance and performance . Do Not: - Always clean in the direction of the grain (original - Do not use corrosive or abrasive detergents, steel...
Troubleshooting DANGER: Turn off the power circuit breaker or the power switch on the junction box before performing maintenance . Touching circuitry inside the range hood while it is energized may result in serious injury or death . Problem Solution - Check that the power supply cable and all electrical wiring are properly The range hood does not operate .
Dimensions Rating Control Type Speeds Light Bulb Wattage Venting Options 757 mm (29.8 in) W Top venting High QR100 120V~60Hz 2 x 40W Incandescent 220 ± Back venting QR101 450 mm (18.4 in) D Push Button 1 .5A E26 base light bulb...
Specifications (continued) EXTERNAL DIAGRAM OF RANGE HOOD 220 mm (8 .66 in) 32 mm (1 .26 in) 378 mm (14 .88 in) 378 mm (14 .88 in) 189 mm (7 .44 in) 39 mm (1 .53 in) 52 mm (2 .04 in) 655 mm (25 .79 in) 705 mm (27 .75 in) 757 mm (29 .8 in)
Service Parts If you are missing parts or if you require replacement parts, please contact our customer service team at cs@conglomkb.com or 1-877-333-0098 (8:30 am – 5 pm, EST, Monday–Friday). Identify the required part(s) and have the part number(s) ready. Part Description Code Quantity...
Page 20
St-Laurent, Québec, H4S 2C3 1-877-333-0098 | cs@conglomkb.com (service available in English and French, Monday - Friday from 8:30am - 5pm EST) www.conglomkb.com Made in China and WESTINGHOUSE are trademarks of Westinghouse Electric Corporation. Used under license by Conglom Inc. All Rights Reserved.