Table of Contents
Advertisement
Maintenance
To prevent spilling oil where it could cause
damage to nature, it is strongly recommend-
ed that you use an oil changer to change the
engine oil. If an oil changer is not available,
drain the engine oil by removing the drain
screw. If you are not familiar with the proce-
dure for changing the engine oil, consult your
Yamaha dealer.
1.
Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01862]
2.
Start the engine. Warm it up and keep
the idle speed for 5-10 minutes.
3.
Stop the engine and leave it for 5-10 min-
utes.
4.
Remove the top cowling.
5.
Remove the oil filler cap. Pull out the dip-
stick and use the oil changer to extract
the oil completely.
82
1. Oil filler cap
1. Oil changer
ZMU08105
TIP:
When using an oil changer, skip steps 6 and
7.
6.
Prepare a suitable container that holds a
larger amount than the engine oil capac-
ity. Remove the drain screw and gasket
while holding the container under the
drain hole. Let the oil drain completely.
Wipe up any spilled oil immediately.
1
1
ZMU08106
ZMU08107
Advertisement
Table of Contents
