Advertisement
Using the Two Safety Pins
Using the Two Safety Pins
1. Turn the RAM POSITION Switch (A) to RAISE, then
press the RAM UP Pushbutton to move the ram to
the fully raised position.
2. To lock ram in the fully raised position, move the
RAM POSITION Switch to the HOLD/NEUTRAL
position and insert both safety hitch pins (106) into
the outer support bars (102) and install both pin lock
clips.
NOTE: Locks that use 1/4 in. shackles can be used in
place of the cotter pins (CP) provided with the safety
hitch pins (106).
CP
F
. 8
IG
3. Once both safety hitch pins (106) are secured, turn
off all air to the system by closing the Main Air
Shutoff Valve on the header (B) and follow your
facility's pre-established lock-out/tag-out
procedures. See F
IG
4. To place the ram back into operation, verify the
RAM POSITION Switch is still in the
HOLD/NEUTRAL position, and open the Main Air
Shutoff Valve on the header (B).
5. Turn the RAM POSITION Switch (A) to RAISE, then
press the RAM UP Pushbutton to move the ram to
the fully raised position.
6. Remove both safety hitch pins (106).
6
106
102
. 4.
3A8499A
Advertisement
