Initial System Configuration
The procedure described below is a presentation of all the questions in the topology configuration.
In actual practice, all questions may not be presented for a particular configuration, depending on
the topology deployed.
Study the examples that follow to understand the procedure for various topologies.
To configure topology dependent parameters, complete the following steps:
Step 1
Enter the topology configuration menu.
Would you like to enter the Topology configuration menu? [no]: y
Type y and press Enter.
The topology configuration dialog begins.
Step 2
Specify the connection mode.
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]:
Specify the deployment type.
Step 3
Is this a cascade deployment? [no]:
Step 4
Specify the physically-connected-link index.
Enter Physically connected link:
0- link-0
1- link-1
Enter your choice [0]:
Specify the SCE 2000 priority.
Step 5
Enter SCE 2000 priority:
1- primary
2- secondary
Enter your choice [1]:
Specify the On-failure link behavior.
Step 6
Enter On-failure behavior:
1- bypass
2- cutoff
Enter your choice [1]:
Step 7
Specify the status of the SCE 2000 after abnormal boot.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
5-20
Chapter 5
Connecting the Management Interfaces and Performing Initial System Configuration
•
To define inline connection mode, press Enter.
To define receive-only connection mode, type 2 and press Enter.
•
To specify a Single-SCE Platform deployment, press Enter.
•
To specify a Cascade deployment, type y and press Enter.
•
•
To specify link-0, press Enter.
To specify link-1, type 1 and press Enter.
•
To specify Primary, press Enter.
•
To specify Secondary, type 2 and press Enter.
•
To specify Bypass, press Enter.
•
To specify Cutoff, type 2 and press Enter.
•
OL-7824-04