Table of Contents
Advertisement
Installing the RSP4+
Follow the steps below to reinstall the RSP4+ that was removed.
Step 1
Hold the RSP4+ handle with one hand and place your other hand under the carrier to support the
RSP4+ and guide it into the slot. (See Figure 2.) Avoid touching the card or any connector pins.
To prevent ESD damage, handle the RSP4+ by the handles and carrier edges only.
Caution
Place the back of the RSP4+ in the slot and align the notch on the carrier with the groove in the slot.
Step 2
(See Figure 1.)
While keeping the RSP4+ parallel to the backplane, carefully slide it into the slot until the back of the
Step 3
faceplate makes contact with the ejector levers, and then stop. (See b in Figure 1.)
Caution
Use the ejector levers to remove or install the RSP4+. Failure to do so can cause erroneous
system error messages indicating a board failure.
Step 4
Using your thumbs, simultaneously push both ejector levers inward until the RSP4+ is pushed entirely
into its slot. (See c in Figure 1.)
Tighten both captive installation screws.
Step 5
Reconnect the cables to the RSP4+.
Step 6
This completes theRSP4+ installation procedure.
Loading and Configuring the Bootflash Image
Using the steps in this procedure, you will:
•
•
•
•
•
•
•
•
•
78-12288-02
Enable the router to enter privileged mode
Confirm the new bootflash size
Format the bootflash
Copy the rsp-boot image onto the bootflash
Confirm that the image has been copied to bootflash
Modify the configuration file to reboot using the new bootflash image
Configure the router to use the bootloader image in bootflash
Save the configuration
Confirm that the configuration reflects the new bootloader image
RSP4+ Bootflash Memory Upgrade to 16MB Installation and Configuration Guide
Installing the RSP4+
15
Advertisement
Table of Contents
