Analogue Tuning The Television - Fine Tuning - Toshiba 32YT56 Series Owner's Manual

Analogue manual tuning
The television can be tuned-in manually using INSTALLATION. For example: if the television cannot be
connected to a media recorder/decoder with a SCART lead or to tune-in a station on another System.
Using Q select PROGRAMME then press R and
2
key in the programme position to be tuned with
the number buttons, we suggest Programme 0 for
a media recorder.
INSTALLATION
PROGRAMME 00
BAND C
CHANNEL 28
I
STANDARD
DECODER
z
FINE TUNING
SEARCH SEARCHING
TUNING MODE CHANNEL
Use Q to select SEARCH then press R ,
3
SEARCHING will flash and the television will
begin searching for channels.
Each signal will show on the television, if it is not
4
your media recorder press R to restart the search.
When your media recorder signal is found, save
5
the selection by pressing Q until STORE is
highlighted, then press R to save.
Repeat for each programme position to be tuned
then press EXIT to finish.
INSTALLATION INSTALLATION
BAND BAND C C
CHANNEL CHANNEL 28 28
I I
STANDARD STANDARD
DECODER DECODER
z z
FINE TUNING FINE TUNING
SEARCH SEARCH
TUNING MODE TUNING MODE CHANNEL CHANNEL
STORE STORE
If the channel number is known the television will
6
search using this information. Using R select
CHANNEL as the TUNING MODE.
Select the PROGRAMME position number as in
7
Step 2, then enter the CHANNEL number.
Highlight SEARCH and press R .
To save the selection press Q until STORE is
8
highlighted, then press R .
fine tuning
f
zx
x
e
f f
zx zx
x x
e e
11
continued
The television will also search by frequency. Select
9
FREQUENCY as the TUNING MODE.
INSTALLATION
PROGRAMME
FREQUENCY
STANDARD
DECODER
SEARCH
TUNING MODE
STORE
Select the PROGRAMME position number, then
10
enter the FREQUENCY number. Highlight
SEARCH and press R .
To save the selection press Q until STORE is
11
highlighted, then press R .
NOTE: If the decoder is connected to the
television by SCART lead to EXT2, the DECODER
option in the INSTALLATION menu must be
selected.
Fine tuning
FINE TUNING should not be required unless there is
interference or a weak signal. It is only available when the
tuning mode is set to channel.
Select the programme position, then press MENU
1
and select INSTALLATION.
Using Q highlight FINE TUNING, then use
2
S or R to adjust to get the best picture and sound.
To save the selection press Q until STORE is
3
highlighted, then press R .
INSTALLATION INSTALLATION
BAND BAND C C
CHANNEL CHANNEL 28 28
I I
STANDARD STANDARD
DECODER DECODER
z z
FINE TUNING FINE TUNING
SEARCH SEARCH
TUNING MODE TUNING MODE CHANNEL CHANNEL
STORE STORE
,
02
527.18 MHZ
I
SEARCHING
FREQUENCY
f f
zx zx
x x
e e