Sharp Notevision PG-C20XE Operation Manual page 16

Connecting the Projector
Connecting RS-232C
When the RS-232C port on the projector is connected to a computer with an RS-232C cable (null modem, cross
type, sold separately), the computer can be used to control the projector and check the status of the projector.
See pages 45 and 46 for details.
1 Connect the supplied DIN-D-sub RS-232C cable to the RS-232C port on the projector.
2 Connect an RS-232C cable (null modem, cross type, sold separately) to the other end of DIN-D-sub RS-232C
cable and to the serial port on the computer.
CAUTION
• Do not connect or disconnect an RS-232C cable to or from the computer while it is on. This may damage your computer.
• The wireless mouse or RS-232C function may not operate if your computer port is not correctly set up. Please refer to the
operation manual of the computer for details on setting up/installing the correct mouse driver.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Authorized Sharp
Industrial LCD Products Dealer or Service Center.
E-15
Port
2 RS-232C cable
(null modem, cross type, sold separately)
DIN-D-sub RS-232C
cable
QCNW-5288CEZZ
1 DIN-D-sub
RS-232C cable
RS-232C
Projector
INPUT 1
AUDIO COM