Faults - Kärcher BR 45/22 C Instruction Manual

1 Screw
2 Cover
 Unscrew 2 screws.
 Swivel the lid downwards.
DANGER
Risk of injury. Turn the appliance switch to "0" and pull the mains plug of the charger prior
to performing any work on the appliance.
ATTENTION
Risk of damage for the appliance due to leaking water. Drain the wastewater and remaining
fresh water prior to performing tasks on the appliance.
In case of faults that cannot be remedied using the table below please contact the customer
service.
Display
The brush drive indi-
cator lamp blinking
orange
The suction indicator
lamp blinking orange
Batter status display
blinking red
Eco mode indicator
lamp blinking blue
Faults with display
Fault
Control is overheated
Brush is blocked.
Control is overheated
Fault during charging pro-
cess.
Battery capacity nearly ex-
hausted, appliance working
at reduced power.
 Loosen and remove the battery plug.
 Remove the left-hand battery.
 Remove the right-hand battery.
 Dispose of the used batteries according
to the local provisions.

Faults

Remedy
Switch off the power switch, wait a few
minutes, switch on the power switch
again.
Check if foreign matters are blocking
the brush roller; remove foreign matter if
required.
Switch off the power switch, wait a few
minutes, switch on the power switch
again.
Disconnect the power cord plug of the
charger. Wait for 10 seconds. Plug in the
power cord plug. If the error message ap-
pears again: Call customer service.
Charge battery.
– 10
EN 25