Moving The Control Panel - LG DF20WKSE Owner's Manual

18
iNSTALLATiON iNSTruCTiONS

MOVING THE CONTROL PANEL

WArNiNg
w
• Disconnect power before servicing.
• Replace all parts and panels before operating.
• Be careful of the sharp edge on the frame to avoid
injury.
• Failure to follow these instructions can result in
death or electric shock.
Disassemble
1 Push to open the cap on the right side of the control
panel.
2 Remove the screw under the cap and set it aside.
3 Slide the control panel about an inch to the right to
free it from the clips.
Control Panel
4 Drop the front of the panel down and disconnect the
wire harness. Remove the panel and set it aside.
Wire harness
Hook
5 Lift the top plate slightly to remove it.
Cap
Frame
Plate
6 Push to open the cap on the right side of the lower
cover.
7 Remove the screw under the cap and set it aside.
8 Slide the lower cover about an inch to the right to free
it from the clips. Set cover aside.
Lower cover
9 Remove the screws holding the safety cover in place
and set the screws and the cover aside.
Safety Cover
Assemble
1 Connect the wire harness on the control panel.
Make sure to push the connector until the hook clicks
into place.
CAuTiON
If the wire harness is not connected properly, the
dryer may not operate.
Wire harness
Cap
Frame