HP Jetdirect J7949e Administrator's Manual page 204

Table 9.9 Error Messages (10 of 10)
Error Code and
Message
5E DHCP LEASE
RELEASED
5F WINS
REGISTRATION
FAILED
61 AUTO IP
CONFIGURED
62 DEFAULT IP
CONFIGURED
63 AUTO IP IN
PROGRESS
64 INVALID
PASSWORD
83 DISCONNECTING
FROM SERVER
84 DHCP LEASE
TIMERS ADJUSTED
F1 TRYING TO
CONNECT TO
SERVER
F2 TFTP IN
PROGRESS
F3 BOOTP/RARP IN
PROGRESS
F4 BOOTP/DHCP IN
PROGRESS
ENWW
Description
The lease for DHCP-configured parameters, including the
IP address, have been released through a manual
configuration method, such as through the printer's control
panel.
Attempts to register the print server's name on the WINS
server failed. Check for duplicate names, or verify the WINS
server configuration.
An IP address could not be retrieved over the network. The
print server will default to an IP address using link-local
addressing in the form 169.254.x.x.
An IP address could not be retrieved over the network.
The print server will default to a legacy default IP address
192.0.0.192.
The print server is automatically assigning an IP address
using link-local addressing in the form 169.254.x.x.
An invalid password was specified through TFTP. Verify that
the password consists of a maximum of 16 printable
characters.
The server has been shut down because of a configuration
change or reset request. This message automatically clears
after a few seconds, unless the printer is offline, is in an error
state, or is servicing another I/O port or another network
protocol.
The print server detected a DHCP lease error due to one of
the following conditions:
● Renew time is less than 30 seconds.
● Rebind time is less than 52 seconds.
Rebind time is less than, or equal to, the Renew time.
●
● The lease duration is less than, or equal to,
the Rebind time.
The HP Jetdirect print server is trying to connect to the
NetWare server(s). This is a normal message. Wait until
either the connection is established or another status
message appears.
The print server is attempting to use TFTP to obtain TCP/IP
configuration settings over the network.
The print server is attempting to use BootP or RARP to
obtain TCP/IP configuration settings over the network.
The print server is attempting to use BootP or DHCP to
obtain TCP/IP configuration settings over the network.
HP Jetdirect Configuration Page 204