Cisco Catalyst C9200L-48PXG-4X-E Hardware Installation Manual page 13

Product Overview
Figure 4: Network Module C9200-NM-4G
1 Module slot
The following table lists the optional Cisco Catalyst 9200 Series Switches uplink network modules with 4x1G,
4x10G, 2x25G, and 2x40G slots.
Table 3: Supported Network Modules
Network Module
C9200-NM-4G
C9200-NM-4X
C9200-NM-2Y
C9200-NM-2Q
C9200-NM-BLANK
Note For information about installing a network module, see
2 LEDs
Description
This module has four 1G SFP module slots. Any combination of standard
SFP modules is supported. SFP+ modules are not supported.
If you insert an SFP+ module in the 1G network module, the SFP+ module
does not operate, and the switch logs an error message. This module is not
supported on C9200 Multigigabit Ethernet switches.
This module has four 10G SFP module slots. Each port supports a 1G or 10G
connection. Any combination of standard SFP modules is supported.
This module is supported on both 1G and Multigigabit Ethernet switch models
of C9200 switches.
This module has two 25 Gigabit Ethernet SFP28 module slots. Any
combination of SFP, SFP+, and SFP28 modules are supported.
This module is supported only on C9200 Multigigabit Ethernet switches.
This module has two 40G slots with a QSFP+ connector in each slot.
This module is supported only on C9200 Multigigabit Ethernet switches.
Insert this blank module when the switch has no uplink ports to enable
sufficient airflow.
Installing a Network Module, on page
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
Uplink Ports
34.
7