Toshiba RAV-SM122KRTP-UL Owner's Manual page 24

■
Wireless remote controller A-B
selection
To separate using of remote control for each indoor
unit in case of 2 air conditioners are installed
nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit
to turn the air conditioner ON.
2. Point the remote control at the indoor
unit.
3. Push and hold
Control by the tip of the pencil. "00" will
be shown on the display. (Picture 1)
4. Press
show on the display and "00" will
disappear and the air conditioner will turn
OFF. The Remote Control B is
memorized. (Picture 2)
Note:
1. Repeat above step to reset Remote
Control to be A.
2. Remote Contrl A has not "A" display.
3. Default setting of Remote Control from
factory is A.
1
23-EN
OM_1121250216_EN_FR_ES.indb 23 OM_1121250216_EN_FR_ES.indb 23
button on the Remote
during pushing "B" will
2
- 23 -
CAUTION
• The FIX and SWING buttons will be disabled
when the air conditioner is not in operation
(including when the ON timer is set).
• Do not operate the air conditioner for long hours
with the airflow direction set downward during the
cooling or dry operation.
Otherwise, condensation may occur on the
surface of the vertical airflow louver and cause
dew dripping.
• Do not move the vertical airflow louver manually.
Always use the FIX button. If you move the
louver manually, it may malfunction during
operation.
If the louver malfunctions, stop the air conditioner
once, and restart.
• When the air conditioner is started immediately
after it was stopped, the vertical airflow louver
might not move for 10 seconds or so.
• Louver operation is limited when performing
group control. (see page 27)
■
Adjust the horizontal airfl ow
Preparation
• Take hold of the lever on the horizontal airflow
louver and move them to adjust the airflow
direction as required.
• You can adjust the airflow at the left, and right
locations of the louver.
Owner's Manual
8/4/2565 BE 13:24 8/4/2565 BE 13:24