Advertisement
Built-In Self-Test (BIST) Instructions
ZC702 Evaluation Kit
Install Driver and Terminal Emulator
STEP 1:
Install the Silicon Labs CP210x USB-to-UART drivers
and a terminal emulator for the USB-to-UART on your
PC.
Install the CP210x USB to UART drivers as described in
www.xilinx.com/kits/cp210x.
Xilinx recommends using Tera Term for terminal
emulation as described in
teraterm.
Note:
If switches, jumpers, or flash memory images
have been changed, refer to
zc702default.
Connect Computer to ZC702 Board
STEP 3:
Connect your computer to J17 on the ZC702 board
using the Type-A to Mini-B USB cable.
Set Up Terminal Emulator: Select COM Port
STEP 5:
Open Tera Term, select Serial, and choose the COM
port that correlates with the Silicon Labs CP210x
USB-to-UART bridge. Click OK. Note the assigned COM
port for Step 7.
www.xilinx.com/kits/
www.xilinx.com/kits/
X-Ref Target - Figure 1-2
Set Switches
STEP 2:
Set DIP switch SW16 to this configuration (00010):
X-Ref Target - Figure 1-3
Connect Power
STEP 4:
Connect the 6-pin power supply plug to J60 and turn
the board on with SW11.
X-Ref Target - Figure 1-4
Set Up Terminal Emulator: Select Serial Port
STEP 6:
Go to Setup and click Serial port to configure the
terminal serial port setting.
2
Advertisement
