Universal Remote System Operation - GMC Acadia 2022 Owner's Manual

GMC Acadia/Acadia Denali Owner Manual (GMNA-Localizing-MidEast-
15170043) - 2022 - CRC - 5/25/21
Learn or Smart Button
4. After completing Steps 1 3, locate the
Learn or Smart button inside the garage
on the garage door opener receiver. The
name and color of the button may vary
by manufacturer.
5. Press and release the Learn or Smart
button. Step 6 must be completed within
30 seconds of pressing this button.
6. Return to the vehicle and firmly press
and hold the trained Universal Remote
system button for two seconds and
release. Repeat the press/hold/release
sequence up to three times to complete
the training process.
The Universal Remote system should now
activate the garage door.
Repeat the process for programming the
two remaining buttons.
Programming for Some Gate Operators
Some gate operators require transmitter
signals to time out or quit after several
seconds of transmission. This may not be
long enough for the Universal Remote
system to pick up the signal during
programming.
If the programming did not work, replace
Step 2 under Programming the Universal
Remote System with the following:
Press and hold the Universal Remote system
button while pressing and releasing the
hand-held transmitter button every
two seconds until the signal has been
successfully accepted by the Universal
Remote system. The Universal Remote
system indicator light will flash slowly at
first and then change to a rapid flash or
continuous solid-light. Proceed with Step 3
under Programming the Universal Remote
System to complete.
Instruments and Controls
Universal Remote System
Operation
Using the Universal Remote System
Press and hold the appropriate Universal
Remote system button for at least one-half
second. The indicator light will come on
while the signal is being transmitted.
Erasing Universal Remote System
Buttons
Erase all programmed buttons when vehicle
ownership is terminated.
To erase:
1. Press and hold the two outside buttons
until the indicator light begins to flash.
This should take about 10 seconds.
2. Release both buttons.
Reprogramming a Single Universal
Remote System Button
To reprogram any of the system buttons:
1. Press and hold any one of the buttons.
Do not release the button.
127